Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
182
Table 12-16 DDNS Configurations
Parameter Description
DDNS Type
You can select the DDNS protocol from the drop-down list, and then
enable the DDNS function. Select the Honeywell DDNS server (which is
free) to enable the DDNS function.
Host IP
This is the DDNS host IP address. Under Honeywell DDNS, the default
server address is www.hennvr-ddns.com.
Domain Mode
Select Default Domain or Custom Domain Name. The default is
Default Domain. If you select Custom Domain Name, then you must
enter a domain name.
Domain Name
The default domain name is MAC address.hennvr-ddns.com.
You can define the prefix.
Username Optional. Enter your email address
Note
Do not register frequently. You need to wait at least 60 seconds between
registration requests. Too many registration requests might leave your server
vulnerable to attacks.
Note
The system DDNS server might take back a domain name that is idle for one
year. If you configure your email address in the DDNS configuration, you will get
a notification email before the domain name is taken back.
Quick DDNS and Client-end Introduction
Background Introduction
If you use ADSL to log into the network, then the device IP is not fixed. The DDNS function
allows you to access the NVR via the registered domain name. Additional to the general
DDNS, the Quick DDNS works with the manufacturer’s device so that it can add the extension
function.
Function Introduction
The quick DDNS client has the same function as other DDNS client ends. It bonds the domain
name and the IP address. Currently, the DDNS server only works with our own devices. You
must regularly refresh the bonding relationship between the domain and the IP. There is no
username, password, or ID registration on the server. However, each device has a default
domain name (generated by the MAC address). You can also use a customized valid domain
name which has not been registered.
Quick DDNS Operation
Before you use Quick DDNS, you must enable this service, and configure the correct server
address, port value, and domain name.
Server address: www.quickddns.com

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet