Web Client Operation
197
Heat Map
The heat map feature detects moving objects in the camera scene that can be generated as a
report based on the object’s heat. The heat colors range from blue to red, with blue
representing the minimum heat value and red representing the maximum heat value. This
information can then be searched and generate reports (see Heat Map on page 160).
Note
This function is only available for
HEN081*4/HEN162*4/HEN163*4/HEN161*4/HEN322*4/HEN323*
4/HEN321*4/HEN642*4/HEN643*4.
1. Go to Setup ïƒ Event ïƒ Heat Map.
Figure 12-68 Heat Map Configuration Interface
2. Select the Channel to configure for heat map from the drop-down menu and check the
Enable check box.
3. To set the periods when heat map is active, next to Period, click Set, and then follow the
steps listed in Motion Detection Configurations on page 190.
Configuring Smart Plan Settings
Smart plan is a master switch for the intelligent analytics such as Face Detection and People
Counting. The device intelligent functions can be valid after smart plan is enabled.
Go to Setup ïƒ Event ïƒ Smart Plan. Select a channel that you want to apply the smart plan to
and select the plan by clicking its icon and click OK.
To Next Page
Loading...
Need help?
General
