HP 1660 Series User Manual

HP 1660 Series Replaceable Parts
Ref.
Des.
HP Part
Number QTY Description
H8 0515-1363 10 MS 3.0 5 TH T10 (disk drive, handle plate)
H9 0515-0680 2 MS 3.0 6 PH T10 (rear panel to HIL connector)
H10 0515-0430 8 MS M3 .0X0 .5X6MM PH T10 (acquisition board, rear panel to
chassis, oscilloscope board on the HP 1660AS series)
H11 0515-2349 5 MS M3.0 X 0.50 - 14MM LG (trim strip cover to cabinet)
H12 0515-1035 2 MSFH M3 8 T10 (line filter)
H13 0515-1103 2 MSFH M3 10 T10 (trim strip cover to cabinet)
H14 0515-0664 4 MSPH M3 12 SMS10 (rear feet to cabinet)
H15 2950-0072 1 NUTH 1/4-32 .062 (intensity adjustment)
H16 2950-0001 2 NUTH 3/8-32 .093 (BNC trigger ports)
H17 0535-0056 3 NUT-HEX (monitor assembly)
H18 1251-5436 1 Screwlock female (RS-232C cable)
H19 0624-0735 4 Screw-taptite 8-32 X .75 (fan)
H20 0515-0382 3 SM assembly M4 X 0.7 12MM-LG (monitor assembly, handle)
H21 0515-1349 4 SM M3 X 0.5 30MM-LG (front panel assembly)
H22 0380-1482 2 STDF-HEX .34-IN (HP-IB cable)
H23 3050-0010 4 WFL.147 .312 .03 (rear feet)
H24 2190-0009 2 WIL.168 .340 .02 (HP-IB cable)
H25 2190-0027 1 WIL.256 .478 .02 (intensity adjustment)
H26 2190-0016 2 WIL.377 .507 .02 (BNC connectors)
H27 0515-1349 4 SMM3X0.5X30MM (front panel assembly)
H28 0515-1031 4 MSF M3 6 T10 (accessory pouch)
H29 2950-0054 2 NUTH 1/2-28 .125 (BNC cal ports, HP 1660AS series only)
H30 2190-0068 2 WIL .505 .630 .02 (BNC cal ports, HP 1660AS series only)
H31 01650-29101 1 Ground Spring (HP 1660AS series only)
H32 54503-25701 2 Hex Nut (attenuator, HP 1660AS series only)
H33 0515-1246 4 MS M3 x 0.5 T10 (attenuator, HP 1660AS series only)
MP1 01660-61606 1 Intensity adjustment assembly
MP2 01660-01203 1 Bracket-disk drive
MP3 3160-0092 1 Fan guard
MP4 01660-00201 1 Rear panel
MP5 54501-62701 1 Line filter/cable assembly
MP6 01660-01205 1 Ground bracket
MP7 01650-01202 1 Ground bracket
MP8 01660-60001 1 Cabinet assembly
MP9 01660-04102 1 Cover assembly
MP10 01660-44901 1 Handle vinyl grip
MP11 01660-01202 1 Handle plate
MP12 01660-01204 1 Handle strap
MP13 35672-21703 2 Strap retainer
MP14 35672-45004 2 Handle end cap
MP15 5041-8801 2 Foot
MP16 1460-1345 2 Tilt stand
MP17 01660-40501 4 Rear foot
MP18 5041-8822 2 Non-skid foot
MP19 01660-45401 1 Circuit board insulator
MP20 01660-01201 1 Circuit board mounting plate
MP21 01660-84501 1 Accessory pouch
MP22 01660-40502 1 Trim strip
Replaceable Parts
Replaceable Parts List
7–6

HP 1660 Series Specifications

General

Category	Logic Analyzer
Glitch Trigger	Yes
Pattern Trigger	Yes
State Analysis	Yes
Transitional Timing	Yes
Trigger Modes	Edge, Pattern, Glitch