Management Processor Lite 112
Table 9-2 Class: HP_ManagementProcessor
Property name Property implementation
Description Description of the Management Processor in the
format:
HP Management Processor - product name
Where:
product name is the name of the MP product (same as
the product name in property ElementName).
Examples:
• HP Management Processor – Integrated Lights Out
(iLO)
• HP Management Processor – Integrated Lights Out
2 (iLO2
• HP Management Processor – Remote Insight
Board Lights Out Edition II (RILOE-II)
• The DNS name of the management processor.
ElementName
CIM_ManagedSystemElement
OperationalStatus Enumerators indicating the Management Processor
operational status (refer to OperationalStatus mapping
table in HP Management Processor (MP) Lite Profile for
specific descriptions of when each value is populated).
• OperationalStatus[0] contains MP operational
status:
○ 0 (Unknown), when NICCondition=0
○ 2 (OK), normal operation
○ 3 (Degraded), when NICCondition=5
○ 6 (Error), when NICCondition=6 or MP
software interface fails
• OperationalStatus[1] contains NIC status (when
MP is enabled):
○ 0 (Unknown), when NICCondition=0 or MP
software interface fails
○ 2 (OK), normal operation
○ 3 (Degraded), when NICCondition=5
○ 6 (Error), when NICCondition=6
○ 10 (Stopped), when NICCondition=3
○ 15 (Dormant), when NICCondition=4
Note: When a Management Processor is disabled
(refer to property EnabledState) OperationalStatus[0]
always reports a status of 2 (OK) so as not to
contribute negatively to overall system status. An MP is
disabled only if the user has manually disabled it via
the MP RBSU settings or if an embedded iLO/iLO2 has
been superceded by the an installed RILOE-II card;
both of these are seen as normal conditions. In this
scenario OperationalStaus[1] is not populated.
To Next Page
Loading...
