4. The stapler/stacker driver rotates M1302 clockwise and moves the jogger guide 3 mm out from
the aligned position (loosen alignment).
The stapler/stacker driver performs the paddle operation during the loosen alignment.
Alignment position
Loose alignment position
3mm
(Top view)
Print paper
Figure 4-53 Paddle operation
5. After the completion of the paddle operation, the stapler/stacker driver changes its controls
depending on whether the fed paper is the last paper of the job or not.
●
If it is not the last sheet of paper, go to step 2.
●
If it is the last sheet of paper, go to step 6.
ENWW Stapler/stacker system 181
manuals4you.commanuals4you.com
To Next Page
Loading...