Menu item Sub-menu item Values Description
Parallel Input
NOTE This
item appears
only if an EIO
accessory is
installed.
High Speed No
Yes (default)
Use the High Speed setting to configure the speed
that the parallel port uses to communicate with the
host.
Advanced Functions Enabled (default)
Disabled
Use the Advanced Functions setting to enable or
disable bidirectional parallel communication.
Embedded Jetdirect See Table 3-10 Jetdirect menus on page 61 for the list of options.
EIO <X> Jetdirect
Table 3-10 Jetdirect menus
Menu item Sub-menu item Sub-menu item Values and Description
TCP/IP Enable Off: Disable the TCP/IP protocol.
On (default): Enable the TCP/IP protocol.
Host Name An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host
name is NPIxxxxxx, where xxxxxx is the last six
digits of the LAN hardware (MAC) address.
IPV4 Settings Config Method Specifies the method that TCP/IPv4 parameters will
be configured on the HP Jetdirect print server.
Bootp: Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
DHCP: Use DHCP (Dynamic Host Configuration
Protocol) for automatic configuration from a DHCPv4
server. If selected and a DHCP lease exists, DHCP
Release and DHCP Renew menus are available to
set DHCP lease options.
Auto IP: Use automatic link-local IPv4 addressing.
An address in the form 169.254.x.x is assigned
automatically.
Manual: Use the Manual Settings menu to configure
TCP/IPv4 parameters.
DHCP Release This menu appears if Config Method was set to
DHCP and a DHCP lease for the print server exists.
No (default): The current DHCP lease is saved.
Yes: The current DHCP lease and the leased IP
address are released.
DHCP Renew This menu appears if Config Method was set to
DHCP and a DHCP lease for the print server exists.
No (default): The print server does not request to
renew the DHCP lease.
Yes: The print server requests to renew the current
DHCP lease.
Table 3-9 Networking and I/O (continued)
ENWW Control-panel menus 61
manuals4you.commanuals4you.com
To Next Page
Loading...