HPE FlexNetwork 5510 HI Series

238
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP IPv6 unicast
address family view,
BGP-VPN IPv6 unicast
address family view, or BGP
IPv6 multicast address family
view.
• Enter BGP IPv6 unicast address
family view:
a. bgp as-number [ instance
instance-name ]
b. address-family ipv6
[ unicast ]
• Enter BGP-VPN IPv6 unicast
address family view:
c. bgp as-number [ instance
instance-name ]
d. ip vpn-instance
vpn-instance-name
e. address-family ipv6
[ unicast ]
• Enter BGP IPv6 multicast address
family view:
f. bgp as-number [ instance
instance-name ]
g. address-family ipv6
multicast
N/A
3. Configure BGP route
reception filtering policies.
• Reference ACL or IPv6 prefix list
to filter BGP routes received from
all peers:
filter-policy { ipv6-acl-number |
prefix-list ipv6-prefix-name }
import
• Reference a routing policy to filter
BGP routes received from a peer
or peer group:
peer { group-name | ipv6-address
[ prefix-length ] } route-policy
route-policy-name import
• Reference an ACL to filter BGP
routes received from a peer or
peer group:
peer { group-name | ipv6-address
[ prefix-length ] } filter-policy
ipv6-acl-number import
• Reference an AS path list to filter
BGP routes received from a peer
or peer group:
peer { group-name | ipv6-address
[ prefix-length ] } as-path-acl
as-path-acl-number import
• Reference an IPv6 prefix list to
filter BGP routes received from a
peer or peer group:
peer { group-name | ipv6-address
[ prefix-length ] } prefix-list
ipv6-prefix-name import
Use at least one method.
By default, no route
reception filtering is
configured.