HT2800T_en_c.doc Page 136 of 275
5 Programming Method
5.1 Method (Headspace mode)
5.1.1 Method Menu
This function is used to edit or view the injection method parameters.
Access sequence: RUN>SETTINGS>METHODS
The “RUN: METHODS” screen contains a list of the 10 methods (from 0 to 9) stored in the unit
memory.
The methods can be identified by the number or by a name.
The name can only be created or edited using a PC (using the “HTA Autosampler Manager”
software). Once the names have been created, they will be visible on the touch screen.
Select a method number/name to enter in the “METHOD X” screen (X is a number from 0 to 9
that can be followed by the method name) and to view or edit its parameters. See paragraph
5.1.2 “Method X: Setting method parameters “.
Select “Tools” to access the “METHOD TOOLS” screen (see paragraph 5.1.3 “Method tools “)
Tap “Exit” to exit from the “RUN: METHODS” screen.
5.1.2 Method X: Setting method parameters
Each method contains a set of analytical parameters. Use this screen to view or edit these
parameters.
Access sequence: RUN>SETTINGS>METHODS>METHOD X
In the “METHOD X” screen the following sub menus are available:
•
General: see paragraph 5.1.2.1;
•
Advanced: see paragraph 5.1.2.2;
•
Preparation: see paragraph 5.1.2.3;
•
Sample: see paragraph 5.1.2.4;
•
Injection: see paragraph 5.1.2.5.
To Next Page
Loading...
