HTA HT2800T - Sequence Tools

HT2800T_en_c.doc Page 156 of 275
• Method: specifies the method to be used;
• First Sample: specifies the number of the first vial to run;
• Last Sample: specifies the number of the last vial to run; all the vials from the first
sample to the last sample position will be run. Therefore, the last sample must be equal
to or higher than the first sample;
• Injection Mode: can have one of the following values:
Default
Uses the injection port defined in the Setup (see paragraph 4.2.6.3 “Setup
configuration: Run “)
Front
Injects
only in the first
injector
Rear
Injects
only in the second injector
Confirmation
It injects the same sample in both front and rear injectors (see paragraph
1 1 ” Appendix A – Glossary” .
• Name: shows the name of the sequence
step. Tap “Exit” to exit from the “STEP X” screen.
If any parameters have been changed, a confirmation screen appears stating “Modifying
sequence step X”. Tap “SAVE” to save the modifications or “CANCEL” to exit without saving.
The display return to the “RUN: SEQUENCES” screen.
6.1.3 Sequence tools
Access sequence: RUN>SETTINGS>SEQUENCES >TOOLS
In the “SEQUENCE TOOLS” screen the following options are available:
• Add New: adds a new sequence step;
• Copy as New: creates a new sequence step by copying parameters from an
existing one;
• Reorder: changes the order of the sequence steps;
• Remove: removes a sequence step.
If you select “ADD NEW” the following message appears: “A new step has been added at
position X”. Tap “CONTINUE” to confirm.
If you select “COPY AS NEW”, first select the source step to copy, then the following message
appears “A new step has been copied at position X”. Tap “CONTINUE” to confirm.