HT2800T_en_c.doc Page 171 of 275
The unit will open the tray (In Liquid mode it opens also the oven cover for the solvent
loading/unloading, see paragraph 7.8).
When the tray is open, samples can be loaded or removed.
Tap “CLOSE” to close the tray after sample loading/unloading.
7.8 Load and Unload Solvent Vials
Only for Liquid Mode
Access sequence: RUN>LOAD SAMPLE/SOLVENT
The unit will open the oven cover (The unit opens also the tray for the sample vial
loading/unloading, see paragraph 7.7).
When the oven cover is open, solvent vials can be loaded or removed.
Tap “CLOSE” to close the oven cover after solvent vial loading/unloading.
7.9 Settings Menu
Access sequence: RUN>SETTINGS
In this screen the following sub menus are available:
•
Methods: see paragraph 5 “Programming Method”;
•
Sequences: see paragraph 6 “Programming Sequence“;
•
Tray Type: see paragraph 7.9.1 “Change tray/rack type”;
•
View Parameters: see paragraph 4.1 “View Parameters”;
•
Setup: see paragraph 4.2 “Setup”;
•
Eco Savings: used to set the stand by parameters (see paragraph 7.9.2 only for
Headspace and SPME mode).
Tap “Exit” to exit from the “RUN: SETTINGS” screen and return to the home screen.
7.9.1 Change tray/rack type
This function is used to change the rack type to be used during the run.
To Next Page
Loading...