HT2800T_en_c.doc Page 245 of 275
10 Uninstalling and disposal
10.1 Autosampler uninstalling
To uninstall the autosampler perform the following operations in sequence:
1. Remove the syringe warmer assembly according to the instructions given in paragraph
Warning
Some parts of the autosampler (oven, syringe, needle or vials) can work at high
temperatures. Be careful to avoid burns. Allow these parts to cool down before handling
them.
Warning
These operations must be completed by competent personnel, properly trained in the
procedures described in this manual: any missing or different execution of the described
procedures can cause damage to the autosampler or to the person working on it.
However, in particular, pay attention to the moving parts such as the sledge, syringe, needle
etc...For the sample handling see paragraph 1.1 “Intended Use and Restrictions” and 1.3
“Warning “.
To Next Page
Loading...
