HTA HT2800T - Sequence Tools

HT2800T_en_c.doc Page 161 of 275
Rear
Desorption in the second injector
• Name: shows the name of the sequence
step. Tap “Exit” to exit from the “STEP X” screen.
If any parameters have been changed, a confirmation screen appears stating “Modifying
sequence step X”. Tap “SAVE” to save the modifications or “CANCEL” to exit without saving.
The display return to the “RUN: SEQUENCES” screen.
6.3.3 Sequence tools
Access sequence: RUN>SETTINGS>SEQUENCES >TOOLS
In the “SEQUENCE TOOLS” screen, the following options are available:
• Add New: adds a new sequence step;
• Copy as New: creates a new sequence step by copying parameters from an
existing one;
• Reorder: changes the order of the sequence steps;
• Remove: removes a sequence step.
If you select “ADD NEW” the following message appears: “A new step has been added at
position X”. Tap “CONTINUE” to confirm.
If you select “COPY AS NEW”, first select the source step to copy, then the following message
appears “A new step has been copied at position X”. Tap “CONTINUE” to confirm.
If you select “REORDER”, you have to select the new step position (target position) and
tap “MOVE”. A screen appears: “Step X has been moved to position Y”. “Y” will be the
new step position.
If you select “REMOVE”, you have to select the step to remove, and then a screen appears:
“Step X has been removed”. Tap “CONTINUE” to confirm. Select “Exit” to exit from this screen
and return to the “RUN: SEQUENCES” screen (see paragraph 6.3.1 “Sequence Menu“).Operations