HTA HT2800T - 3.5 PC connection and software installation

HT2800T_en_c.doc Page 61 of 275
3.5 PC connection and software installation
“HTA Autosampler Manager” software is optional. See paragraph 1.6 “Functions available only
through HTA Autosampler Manager”.
Warning
HTA Autosampler Manager comes in two versions: Standard version and CFR 21 Part 11 version.
In the document in which is reported the Activation key you will find information about the version
for which you have been granted a license.
An activation key is required to enable communication with the autosampler. Every autosampler has its
own key which is associated with its serial number. Without the activation key, the software can
only be used in "DEMO" mode.
In the Demo mode you can not:
• run a sample list, a single injection or washes;
• read from/download to the autosampler methods, sequences and set up settings;
• see the virtual screen.
3.5.1 Autosampler controlled by LAN-connected PC
3.5.1.1 Default IP address
The factory Ethernet configuration of the autosampler is as shown below (it may be subject to change):
• IP Address:192.168.0.207
• Subnet Mask: 255.255.0.0
Warning
The virtual screen is available only with LAN connection. It is not available with RS232
connection.