HTA HT2800T - Syringe Installation; Replacement (Liquid Mode)

HT2800T_en_c.doc Page 101 of 275
Warning
If syringeID system is used, be careful while handling the syringe holder of the SyringeID
system (1.7.2 “Options“). Do not touch the connector or the electronic circuit placed on
the back of the holder. The components may be damaged. If not used, the SyringeID
holder must be stored in the antistatic bag supplied with the packaging.
4.2.3 Syringe installation/ replacement (liquid mode)
Access sequence: RUN>SETTINGS>SETUP>SYRINGE INSTALLATION
Warning
If syringeID system is used, the syringe information are loaded in a RFID tag included in
the black adapter mounted on the syringe for the syringeID system (see paragraph 11.2
“Liquid mode“). Every adapter must be associated to a syringe only in order to maintain
the info regarding the syringe always correct and updated. Do not remove the syringe
from its black adapter.