HT2800T_en_c.doc Page 84 of 275
4 Set Up operations
4.1 View Parameters
Access sequence: RUN>SETTINGS>VIEW PARAMETERS
This information is organized on multiple pages: press NEXT to change the page.
View parameters shows the following information:
•
Syringe Volume: nominal volume of the installed syringe;
•
Tray Type: the tray type installed. This shows the number of vial positions,
dimension of sample vials and needle draw depth inside the vial;
•
Analyzer Brand: shows the analyzer brand (see paragraph 4.2.1.1 “Alignment:
Analyzer Default“);
•
Analyzer Model: shows the analyzer model (see paragraph 4.2.1.1 “Alignment:
Analyzer Default“);
•
Front Injector Depth: shows the needle insertion depth into the front injection port;
•
Front Injector Insertion Speed: shows the needle insertion speed into the injector;
•
Rear Injector Depth: shows the needle insertion depth into the rear injector.
This parameter is shown only if the autosampler is set to work with the rear injector;
Warning
Set-up must be completed by competent personnel, properly trained regarding the
procedures described in this manual: any missing or different execution of the described
procedures can cause damage to the autosampler or to the person operating it.
However, in particular, you should pay attention to the moving parts such as the sledge,
syringe , needle, the cover of the oven etc...Some parts of the autosampler (oven,
syringe, needle or vials) can work at high temperatures. Be careful to avoid burns. Allow
these parts to cool down before handling them.
To Next Page
Loading...
