HTA HT2800T - 5.2 Method (Liquid mode)

HT2800T_en_c.doc Page 141 of 275
Preparation
Shaker On
0.2
Shaker Off
0.1
Sample
Sample Volume
0.5
Fill Volume
1ml
Pull Up Strokes
2
Equilibration Delay
1s
Sample speed
6ml/min
Syringe Prefill
No
Injection Injection Speed
15-30ml/min
Pre Injection Dwell
1
Post Injection Dwell
3
Flush TIme
3min (1 bar)
5.2 Method (Liquid mode)
5.2.1 Method Menu
This function is used to edit or view the injection method parameters.
Access sequence: RUN>SETTINGS>METHODS
The “RUN: METHODS” screen contains a list of the 10 methods (from 0 to 9) stored in the unit
memory.
The methods can be identified by the number or by a name.
The name can be created or edited only using a PC (using the “HTA Autosampler Manager”
software). Once the names have been created, they will be visible on the touch screen.
Select a method number/name to enter in the “METHOD X” screen (X is a number from 0 to 9
that can be followed by the method name) and to view or edit its parameters. See paragraph
5.1.2 “Method X: Setting method parameters “.
Select “Tools” to access to the “METHOD TOOLS” screen (see paragraph 5.1.3 “Method tools”).
Tap “Exit” to exit from the “RUN: METHODS” screen.