HT2800T_en_c.doc Page 159 of 275
step in the rear injector (then it waits for the GC to run the samples), the third vial of the step
in the front injector, the fourth vial of the step in the rear injector and so on...
High Throughput Mode will only work on GCs that have two injection ports.
High Throughput Mode is only supported during automatic run (not single injection)
6.2.3 Sequence tools
Access sequence: RUN>SETTINGS>SEQUENCES >TOOLS
In the “SEQUENCE TOOLS” screen, the following options are available:
•
Add New: adds a new sequence step;
•
Copy as New: creates a new sequence step by copying parameters from an
existing one's;
•
Reorder: changes the order of the sequence steps;
•
Remove: removes a sequence step.
If you select “ADD NEW” the following message appears: “A new step has been added at
position X”. Tap “CONTINUE” to confirm.
If you select “COPY AS NEW”, select first the source step to copy, then the following message
appears “A new step has been copied at position X”. Tap “CONTINUE” to confirm.
If you select “REORDER” you have to select the new step position (target position) and tap
“MOVE”. A screen appears “Step X has been moved to position Y”. “Y” will be the new step
position.
If you select “REMOVE”, you have to select the step to remove, then a screen appears “Step X
has been removed”. Tap “CONTINUE” to confirm.
Select “Exit” to exit from this screen and return to the “RUN: SEQUENCES” screen (see
paragraph 6.2.1 “Sequence Menu”).
6.3 Sequence: SPME mode
6.3.1 Sequence Menu
This function is used to edit a sample list (later refered to as Sequence). Access sequence:
RUN>SETTINGS>SEQUENCES
To Next Page
Loading...
