HTA HT2800T - 7.10 Change Mode

HT2800T_en_c.doc Page 174 of 275
Off
The valve is closed.
Select “Exit” to exit from the “Eco Savings” screen and return to the home screen.
7.10 Change Mode
This function is used to change the autosampler mode.
Access sequence: RUN>CHANGE MODE
In this screen you can switch the mode:
• Headspace: switches to the Headspace mode;.
• Liquid: switches to the liquid mode;
• SPME: switches to the SPME mode;
In this screen you can see the current mode (Last Used Configuration). At the first autosampler
switch on, the default mode is “Headspace”.
Tap the button corresponding to the current mode to exit from the “Change Mode” screen and
return to the home screen.
Each switching operation is followed by a dedicated wizard. In the following paragraphs you can
find a description of the operations to be performed for each switch:
• Change from Headspace to Liquid mode (7.10.1)
• Change from SPME to Liquid mode (7.10.2)
• Change from Liquid to Headspace mode (7.10.3)
• Change from Liquid to SPME mode (7.10.4)
• Change from Headspace to SPME mode (7.10.5)
• Change from SPME to Headspace mode (0).