HTA HT2800T - External Cleaning of Cabinet; Incubation Oven Cleaning

HT2800T_en_c.doc Page 233 of 275
• Dry with a dry cloth.
• Replace the rack inside the tray and close the tray.
9.1.2 External cleaning of cabinet
• Switch OFF the autosampler.
• Remove the power cable from the rear.
• Carefully clean the control panel (touch screen or keypad) and fragile parts using
only a damp cloth. They must not be cleaned with solvents or detergents.
• Clean the cabinet using a non-abrasive detergent solution.
• Dry with a dry cloth.
Do NOT use water, solvents, detergents or spray on electrical parts.
9.1.3 Incubation oven cleaning
• Be sure that the autosampler is in stand-by status and that no other operations are in progress.
• Set the oven stand-by temperature to off (see paragraph 7.9.2 “Eco Savings”);
• Enter “manual operations” and open the oven cover (see paragraph 4.2.5 “Setup: Manual
operations”);
• Turn OFF the autosampler and remove the power cable;
• Wait until the incubator oven cools down;
• Remove the spacers (if present) using the suitable tweezers ;
• Clean the incubator and the spacers;
• Reinstall the spacers (if needed);
• Let the oven dry;
• Connect the autosampler to the power supply and switch ON the unit;
Warning
Oven surface and spacers (when inserted) are heated at high temperature and can be
very hot. We recommend taking care in order to prevent burns.