HTA HT2800T - Mechanical Errors; Heating Errors

HT2800T_en_c.doc Page 219 of 275
To perform the syringe wash, single injection, or automatic run it is necessary to disable the
SyringeID system because it is not working correctly (see paragraph 4 . 2 . 6 . 8 Setup
configuration: SyringeID) .
To solve the problem regarding the SyringeID system contact the Technical Assistance Centre.
8.13 Mechanical errors
Error message:
“Name motor error: Code XXX”
(Where “Name motor” can be Plunger, Needle, Turret, Tray, Shaker and “XXX” specifies the
error).
The code is useful for technical purposes but does not give a definitive cause.
Causes:
The autosampler can not complete a movement.
Solution:
Check the unit for obstacles and remove if present. You can tap “DISENGAGE” to enter “Manual
operations” and move the locked motors and try to solve the problem (see paragraph 4.2.5
“Setup: Manual operations). Tap “EXIT” to return to the main menu
If the problem isn't solved, switch the autosampler OFF, wait 30 seconds and switch it ON again.
Retry the operation.
If the problem persists contact the Technical Assistance Centre, supplying the error message
and error code.
8.14 Heating errors
Only for Headspace and SPME mode.
Error message:
“Warning”
“Y heater: Code XXX Oven: ZZZ°C (WWW°C) Syringe: KKK°C (JJJ°C)
(“Y” can be the Oven or the Syringe according to the heater that has generated the error, “XXX”
specifies the error, “ZZZ” is the set temperature for the oven, “WWW is the read temperature for
the oven, “KKK” is the set temperature for the syringe, “JJJ” is the set temperature for the
syringe).
The code is useful for technical purposes but does not give a definitive cause.
Causes:
The autosampler can not complete an operation.