HTA HT2800T - Page 163

HT2800T_en_c.doc Page 163 of 275
• Change mode: to change the current autosampler mode (Headspace, Liquid, SPME)
(see paragraph 7.10).
Liquid mode:
• Single Injection: performs an injection from a specific sample vial (see paragraph 7.2);
• Automatic Run: performs an automatic cycle of injections from different sample vials
(see paragraph 7.3);
• Syringe Wash: washes the syringe with solvent (see paragraph 7.5);
• Load Sample/Solvent: opens the tray to load/unload the samples and open the oven
cover to load/unload the solvent vials (see paragraph 7.7 and 7.8);
• Settings: accesses other autosampler functionalities and menus (see paragraph 7.9).
• Change mode: to change the current autosampler mode (Headspace, Liquid, SPME)
(see paragraph 7.10).
SPME mode:
• Single Injection: performs an injection from a specific sample vial (see paragraph 7.2);
• Automatic Run: performs an automatic cycle of injections from different sample vials
(see paragraph 7.3);
• Fiber Cleaning Conditioning: conditions or cleans the Fiber (see paragraph 7.6);
• Load Sample Tray: opens the tray to load/unload the samples (see paragraph 7.7);
• Settings: accesses other autosampler functionalities and menus (see paragraph 7.9).
• Change mode: to change the current autosampler mode (Headspace, Liquid, SPME)
(see paragraph 7.10).
Tap one of these options to enter the respective sub menu.
To move to the Quick Start User Interface, see paragraph 4.2.6.3 “Setup configuration: Run”.