HT2800T_en_c.doc Page 225 of 275
2) Click on “Modify network configuration of autosampler” and then on “Proceed”. In this
way an automatic procedure start to change the network configuration of your
autosampler and make it compatible with your PC. The following screen appears:
Figure 187: Connection troubleshooting_2
3) The IT/ network administrator must check that the suggested network parameters (IP
address, Subnet mask, gateway) are actually compatible with your network.
4) If the checking passes, click on “Next” to start the automatic assignment of the new
network configuration of your autosampler.
To Next Page
Loading...
