HTA HT2800T - Page 272

HT2800T_en_c.doc Page 272 of 275
Figure 88: Vial locator positioning 76
Figure 89: Vial locator removing 76
Figure 90: Vial locator replacing step 1 77
Figure 91: Vial locator replacing step 2 77
Figure 92: Needle tip-vial locator alignment 78
Figure 93: Recommended fill volumes for sample vials 79
Figure 94: Crimper 80
Figure 95: Correct crimp 80
Figure 96: Syringe installation screen 92
Figure 97: Syringe positioning screen 92
Figure 98: Syringe remove and installation screen 93
Figure 99: Syringe Install Manual Move screen 93
Figure 100: Sliding lid opening 94
Figure 101: Plunger locker removing 94
Figure 102: Retaining nuts removing 95
Figure 103: Syringe warmer assembly removal 96
Figure 104: Syringe warmer assembly positioning 97
Figure 105: Retaining nuts repositioning 98
Figure 106: Plunger locker positioning 98
Figure 107: Sliding lid closing 99
Figure 108: Syringe volume setting screen 99
Figure 109: Syringe installation screen 102
Figure 110: Syringe positioning screen 102
Figure 111: Syringe remove and installation screen 103
Figure 112: Syringe Install Manual Move screen 103
Figure 113: Plunger locker removing 103
Figure 114: Syringe locker removing 104
Figure 115: Syringe locker removing (syringeID system purchased and installed)
104
Figure 116: Old Syringe removal 105
Figure 117: Old Syringe removal (syringe with syringeID) 105
Figure 118: Syringe positioning 106
Figure 119: Syringe with syringeID positioning 106
Figure 120: Syringe locker positioning Figure 121: Syringe locker positioning
(syringeID) 107
Figure 122: Plunger locker positioning 107
Figure 123: Sliding lid closing 108
Figure 124: Syringe volume setting screen 108
Figure 125: Syringe supplied with o-ring installation in the syringe location 109
Figure 126: Reinforcement application on the syringe 110
Figure 127: Syringe with Reinforcement installation in the syringe location 110
Figure 128: Fiber Holder installation screen 111
Figure 129: Fiber holder positioning screen 112