HTA HT2800T - Page 274

HT2800T_en_c.doc Page 274 of 275
Figure 166: Syringe warmer assembly mounting 193
Figure 167: Mount Headspace vial locator 194
Figure 168: Rack for 6/10720ml vials installation 194
Figure 169: Spacer removal 195
Figure 170: Change from liquid to Headspace mode_Remove vial locator 196
Figure 171: Liquid syringe removal 197
Figure 172: Liquid syringe holder removal (syringeID system purchased and enabled)
197
Figure 173: Liquid syringe holder removal 198
Figure 174: Liquid syringe removal (syringeID system purchased and enabled)
198
Figure 175: Fiber holder mounting 199
Figure 176: Mount Headspace vial locator 200
Figure 177: Rack for 20ml vials installation 200
Figure 178: Spacer removal 201
Figure 179: Syringe warmer assembly removal 202
Figure 180: Fiber holder mounting 203
Figure 181: SPME Fiber holder removal 205
Figure 182: Syringe warmer assembly mounting 206
Figure 183: Damage to the syringe needle 221
Figure 184: Syringe inspection 222
Figure 185: Tray opening by hand 223
Figure 186: Connection troubleshooting 224
Figure 187: Connection troubleshooting_2 225
Figure 188: Exploded view of the syringe warmer assembly 235
Figure 189: Main screw 235
Figure 190: Removing the upper cover and the syringe plunger 236
Figure 191: Syringe warmer assembly disassembling_1 236
Figure 192: Syringe warmer assembly disassembling_2 237
Figure 193: Lower spacers positioning 237
Figure 194: Insulating gasket positioning 238
Figure 195: Upper spacer positioning 238
Figure 196: Syringe holder positioning 239
Figure 197: Syringe barrel mounting inside the heating body 239
Figure 198: Syringe plunger replacing 240
Figure 199: Fiber mounting in the Fiber holder_1 241
Figure 200: Fiber mounting in the Fiber holder_2 241
Figure 201: Fiber mounting in the Fiber holder_3 242
Figure 202: Fiber mounting in the Fiber holder_4 242
Figure 203: Apply the tower protection 247
Figure 204: Apply the polythene bag 247
Figure 205: Apply the protection belt 247
Figure 206: Position the lower cushions 248