HT2800T_en_c.doc Page 80 of 275
Figure 94: Crimper
You must have a crimper available. Fit the
septum on the cap, then:
•
Clean the inside surfaces of the crimper jaws.
•
Place the crimp cap over the top of the vial.
•
Hold the vial and place the crimper on top of it. Squeeze the handle until it touches the
adjuster screw.
Check each vial for proper crimping. Correct
crimp features:
•
flat cap surface;
•
flat septa surface;
•
tight fitting of the cap edge;
•
plain and undeformed cap sides.
Figure 95: Correct crimp
To Next Page
Loading...
