Huawei Quidway S3000-EI Series User Manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 2
QoS Configuration
Huawei Technologies Proprietary
2-6
her way,
For details about the command, refer to the Command Manual.
2.2.4 Port Traffic Limit
T the port-based line r e general speed of
p
You can use the following command to configure port traffic limit.
Perform the following configuration in Ethernet port view.
ort traffic limit
The purpose of this configuration task is to implement the traffic policing over the data
flow matching the ACL. The traffic beyond the limit will be dealt with in some ot
such as discarding.
he port traffic limit is ate used for limiting th
acket output on the port.
Table 2-4 Configuring p
Operation Command
Configure the port traffic limit
line-rate target-rate
Cancel the configuration port traffic limit
undo line-rate
f configuring configure a traffic limit for a single
port.
2.2.5 Con
CPU or other output
You can use the following command to configure the packet redirection.
w.
Table 2-5 Config tion
Ethernet Switch supports the function o
For details about the command, refer to the Command Manual.
figuring Packet Redirection
Packet redirection is to redirect the packets to be forwarded to
port.
Perform the following configuration in system vie
uring redirec
Operation Command
Configure
redirection
u acl-name } [ rule rule ] |
{ ip-group { acl-number | acl-name } [ rule rule ] | link-group
{ acl-number | acl-name } [ rule rule ] }* } { cpu | interface
{ interface-name | interface-type interface-num } }
traffic-redirect { user-gro p { acl-number |
Cancel the
redirection
undo traffic-redirect { user-group { acl-number | acl-name } [ rule
rule ] | { ip-group { acl-number | acl-name } [ rule rule ] | link-group
configuration { acl-number | acl-name } [ rule rule ] }* }
Note that the packets redirected to the CPU will not be dealt.

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English