Huawei Quidway S3000-EI Series User Manual

Operation Manual - VLAN
Quidway S3000-EI Series Ethernet Switches Chapter 3
GARP/GVRP Configuration
Huawei Technologies Proprietary
3-2
 Note:
z he value of GARPT timer will be used in all the GARP applications, including GVRP
RP, running in one switching network.
z
and GM
In one switching network, the GARP timers on all the switching devices should be
set to the same value. Otherwise, GARP application cannot work normally.
3.1.2 Set GARP Timer
GARP timers include Hold timer, Join timer, Leave timer and LeaveAll timer.
ipant sends Join Message regularly when Join timer timeouts so that
When the GARP participant wants to remove some attribute values, it will send Leave
ave timer expires, the GARP
, Leaveall timer is restarted and a new cycle
upon timeout of the hold timer. In this way, all the VLAN registration information
received within the time specified by the Hold timer can be sent in one frame so as to
The GARP partic
other GARP participants can register its attribute values.
Message outward. The GARP participant receiving the information will start the Leave
timer. If Join Message is not received again before the Le
attribute values will be removed
LeaveAll timer will be started as soon as the GARP participant is enabled. LeaveAll
message will be sent upon timeout so that other GARP participants will remove all the
attribute values of this participant. Then
begins.
When the switch receives some GARP registration information, it will not send Join
Message immediately. Instead, it will enable a hold timer and send the Join Message
outward
save the bandwidth resource.
Configure Hold timer, Join timer and Leave timer in Ethernet port view. Configure
LeaveAll timer in system view.
Table 3-1 Set GARP timer
Operation Command
Set GARP Hold timer, Join timer and
Leave timer
garp timer { hold | join | leave }
timer_value
Set GARP LeaveAll timer
garp timer leaveall timer_value
Restore the d Hold timer,
undo garp tim in | leave }
efault GARP
Join timer and Leave timer settings
er { hold | jo
Restore the default GARP LeaveAll
mer leaveall
timer settings.
undo garp ti

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English