Huawei Quidway S3000-EI Series User Manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 3
Logon User ACL Control Configuration
Huawei Technologies Proprietary
3-6
CL to control HTTP users
The follow section introduces the configuration procedures.
3.4.1 Defi
So far, you can only call the numbered basic ACL, ranging from 2000 to 2999, to
ame configuration commands introduced in
the last section.
3.4.2 Call
defined ACL.
.
Perform the following configuration in system view.
Table 3-4 Calling ACL to control HTTP users
2) Calling A
ning ACL
implement ACL control function. Use the s
ing ACL to Control HTTP Users
To control the WEB network management users with ACL, call the
You can use the following commands to call an ACL
Operation Command
Call an ACL to control the WEB NM users.
ip http acl acl-number
Cancel the ACL control function.
undo ip http acl
For more about the c
 :
ommands, refer to the Command Manual.
Note
Only the numbered b r control. asic ACL can be called for WEB NM use
3.4.3 Conf Examp
I. Networking requirements
iguration le
Only permit WEB NM user from 10.110.100.46 access switch.

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English