Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 2 MAC Address Table Management
Huawei Technologies Proprietary
2-4
Restore the default Max Count of MAC Address
Learned by a Port
undo mac-address
max-mac-count
By default, there is no limit to the MAC addresses learned via the Ethernet port.
2.3 Display and Debug MAC Address Table
After the above configuration, execute display command in any view to display the
running of the MAC address table configuration, and to verify the effect of the
configuration.
Table 2-4 Display and debug MAC address table
Operation Command
Display the information in the
address table
display mac-address [ mac-addr [ vlan vlan-id ] |
[ static | dynamic ] [ interface { interface-name |
interface-type interface-num } ] [ vlan vlan-id ]
[ count ] ]
Display the aging time of
dynamic address table entries
display mac-address aging-time
2.4 MAC Address Table Management Configuration Example
I. Networking requirements
The user logs in the switch via the Console port to configure the address table
management. It is required to set the address aging time to 500s and add a static
address 00e0-fc35-dc71 to Ethernet 0/2 in vlan1.