Huawei Quidway S3000-EI Series User Manual

Operation Manual - VLAN
Quidway S3000-EI Series Ethernet Switches Chapter 2
Isolate-User-Vlan Configuration
Huawei Technologies Proprietary
2-3
rm these operations after removing the mapping relationship.
hip
between the specified isolate-user-vlan and the specified Secondary VLAN will be
2.2.4 Con
e the following command to configure VLAN ID of IGMP packets sent to the
route interface.
N view.
After the mapping relationship is configured, the system does not allow you to
add/remove any ports to/from the isolate-user-vlan or Secondary VLAN or remove a
VLAN. You can perfo
Without the specified secondary secondary_vlan_numlist parameter, the undo
isolate-user-vlan command will remove the mapping relationship between the
specified isolate-user-vlan and all the Secondary VLANs. Otherwise the relations
removed.
figure VLAN ID of IGMP packets
You can us
Perform the following configurations in VLA
Table 2-4 Configure VLAN ID of IGMP packets
Operation Command
Cause IGMP packets to be sent to the route
te-user-vlan igsp enable
interface with Secondary VLAN ID
isola
Restore the default VLAN ID of IGMP
packets to be sent to the route interface
undo isolate
enable
-user-vlan igsp
B h isolate-
2.3 Disp
fter the above configuration, execute display command in any view to display the
erify the effect of the
configuration.
y default, IGMP packets are sent wit user-vlan ID.
lay and Debug isolate-user-vlan
A
running of the isolate-user-vlan configuration, and to v
Table 2-5 Display and debug isolate-user-vlan
Operation Command
Display the mapping relationship
between the isolate-user-vlan and
Secondary VL
display isolate-user-vlan
AN
[ isolate-user-vlan_num ]

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English