Operation Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 2
IGMP Snooping Configuration
Huawei Technologies Proprietary
2-8

By default, no filtering configured on the switch.
Note:
z Each VLAN of each port can only be ne ACL rule.
z
N, the filtering configured by this effect.
Most devices just broadcast unknown multicast packets, s o to prevent the case
st packets to the filtered ports,
ation with the unknown multicast
dropping function.
configured with o
If no ACL rule is configured or the c
VLA
onfigured port doesn’t belong to the specified
command will not take
z
where multicast data flow is sent as unknown multica
this function is generally configured in combin
2.2.8 Mul
Th
pre
I. En
Perform the following configuration in system view or Ethernet port view.
able 2-8 Enable/disable multicast source port suppression function
ticast Source Port Suppression Configuration
is feature is to filter multicast packets on an unauthorized multicast source port,
venting the user that connects to this port from setting multicast server privately.
abling/Disabling Multicast Source Port Suppression
T
Operation Command
Enable multicast source port multicast-source
suppression
-deny [ interface
interface-list ]
Disable multicast source port
suppression
undo multicast-source-deny
[ interface interface-list ]
By default, the multicast source port suppression function is disabled on all ports.
z In system view, if the interface-list parameter is not specified, it means that to
all ports of the
switch; if the interfa st parameter is specified, it mean nable it on the
specified po
z ie
mmand only to enable the feature o rt
II. nd Debugging Multicast S
fter the above configuration, perform the display command in any view, you can view
tion
result.
enable this function globally; that is, to enable this function on
ce-li
rt.
s that to e
In Ethernet port view, the interface-list p
use this co
arameter cannot be specif d, and you can
n the current po
Displaying a ource Port Suppression
A
the running state of multicast source port suppression, and check the configura