Huawei Quidway S3000-EI Series User Manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 2
HGMP V2 Configuration
Huawei Technologies Proprietary
2-12
ludes:
z Enable/Disable cluster function
Enter cluster view
ster IP address pool
Name the administrator device and cluster.
Cluster configuration inc
z
z
Configure clu
z
z
Add/delete a cluster member device
z Setup a cluster automatically.
z Member accessing
z Set cluster holdtime.
z Set cluster timer to specify the handshaking message interval.
z Configure FTP/TFTP Servers and Logging/SNMP Hosts for a Cluster.
 Note:
You need to enable the cluster function and configure cluster parameters on an
administrator device. However, you only have to enable the cluster function on the
member devices and Candidate devices.
2.4.2 Enable/Disable Cluster Function
re using it.
system view.
ble cluster function
Enable the cluster function befo
Perform the following configuration in
Table 2-13 Enable/Disa
Operation Command
Enable cluster function.
clu
ster enable
Disable cluster function.
undo cluster enable
Above commands can be used on any device supporting the cluster function. When
ystem will
elete the cluster and disable the cluster function on it. When you use it on a member
device, the system will exit the cluster and disable the cluster function on it.
the cluster function is enabled.
2.4.3 Enter cluster view
re the cluster function.
ollowing configuration in system view.
you use the undo cluster enable command on an administrator device, the s
d
By default,
You must enter cluster view before configu
Perform the f

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English