Huawei Quidway S3000-EI Series User Manual

Operation Manual - STP
Quidway S3000-EI Series Ethernet Switches Chapter 1
MSTP Region-configuration
Huawei Technologies Proprietary
1-10
1.2 Con
or a switch
h as primary or secondary root switch
z Configure the MSTP running mode
ity for a switch
ion
witch
a port
oint link
a port
ion
other configurations take effect. Before
ed parameters of the device and Ethernet
ts nabling MSTP and stay effective even after resetting
can show the region parameters yet to take effect. The
ask description or the Command Manual.
secondary root bridge, ROOT PROTECTION, BPDU PROTECTION, protocol hot
swapping, master/slave switchover, and so on.
figure MSTP
MSTP configuration includes:
z Configure the MST region f
z Specify the switc
z Configure the Bridge prior
z Configure the max hops in an MST reg
z Configure the switching network diameter
z Configure the time parameters of a s
z Configure the max transmission speed on
z Configure a port as an edge port
z Configure the Path Cost of a port
z Configure the priority of a port
z Configure the port (not) to connect with the point-to-p
z Configure the mCheck variable of
z Configure the switch security funct
z Enable MSTP on the device
z Enable MSTP on a port
Only after MSTP is enabled on the device will
enabling MSTP, you can configure the relat
por , which will take effect upon e
MSTP. The check command
display active-region-configuration command shows the parameters configured
before MSTP is enabled. For those configured after MSTP is enabled, you can use the
related display commands to display. For detailed information, refer to the “Display and
Debug MSTP” section. .
You do not have to perform all the mentioned tasks to configure MSTP. Many of them
are designed to adjust the MSTP parameters provided with default values. You can
configure these parameters per the actual conditions or simply take the defaults. For
detail information, refer to the t
 Note:
When GVRP and MSTP startup on the switch simultaneously, GVRP packets will
propagate along CIST which is a spanning tree instance. In this case, if you want to
sue a certain VLAN through GVRP on the network, you should make sure that the
VLAN is mapped to CIST when configuring the VLAN mapping table of MSTP.
is

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English