Operation Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 2
IGMP Snooping Configuration
Huawei Technologies Proprietary
2-9
Table 2-9 Display and debug multicast source port suppression
Operation Command
Dis lticast source
[ interface { interface_type
play statistics about mu
display multicast-source-deny
port suppression
[ interface_number ] | interface_name } ]
port checking
rmation about this port is displayed.
2.3 Display and debug IGMP Snooping
A
r Snooping configuration .
Execute debugging command in user view to debu
Table 2-10 Display and debug IGMP Snooping
If the port type and port number are not specified, the multicast source
information about all ports on the switch is displayed; if only the port type is specified,
the multicast source port checking information about all ports of this type is displayed; if
both the port type and port number are specified, then the multicast source port
checking info
fter the above configuration, execute dis
unning of the IGMP
play command in any view to display the
, and to verify the effect of the configuration
g IGMP Snooping configuration.
Operation Command
Display the information about current
IGMP Snooping configuration
display igmp-snooping configuration
Display IGMP Snooping statistics of
received and sent messages
displa
y igmp-snooping statistics
Display IP/MAC multicast group
information in the VLAN
display
vlanid ]
igmp-snooping group [ vlan
Enable/disable IGMP Snooping
debugging (abnormal, group, packet,
timer).
debugging igmp-snooping { all |
abnormal | group | packet | timers }
Disable IGMP Snooping debugging undo debugging igmp-snooping { all |
(abnormal, group, packet, timer). abnormal | group | packet | timers }
2.4 IGMP
2.4.1 Enab
I. N
T ing on the switch, The switch is connected
w
Snooping Configuration Example
le IGMP Snooping
etworking requirements
o implement IGMP Snoop first enable it.
ith the router via the router port, and with user PC through the non-router ports.