Operation Manual - Port
Quidway S3000-EI Series Ethernet Switches Chapter 1
Ethernet Port Configuration
Huawei Technologies Proprietary
1-4
operate in full-duplex, half-duplex or
auto-negotiation mode be set as per the requirement
T pport full dupl in
full ) mode.
The Gi uplex or
uto-negotiation mode. When the port operates at 1000Mbps, the duplex mode can be
1.3.2 Set
You can use the following command to set the speed on the Ethernet port. If the speed
Perform the following confi ation in Ethernet port view.
Table 1-5 Set speed on Ethernet port
Note that, 100M electrical Ethernet port can
, which can s.
he optical 100M/Gigabit Ethernet ports su
(full duplex) or auto (auto-negotiation
ex and can be set to operate
gabit electrical Ethernet port can operate in full duplex, half d
a
set to full (full duplex) or auto (auto-negotiation).
The port defaults the auto (auto-negotiation) mode.
Speed on the Ethernet Port
is set to auto-negotiation mode, the local and peer ports will automatically negotiate
about the port speed.
gur
Operation Command
Set 100M Ethernet port speed
speed { 10 | 100 | auto }
Set Gigabit Ethernet port speed
speed { 10 | 100 | 1000 | auto }
Restore the default speed on Ethernet port
undo speed
Note that, the 100M electrical Ethernet port can operate at 10Mbps, 100Mbps or
requirements.
100M optical Ethe ports 100Mbps and can be co perate at 100
( ion).
T pports the 10 n be
s
The electrical Gigabit Ethernet port can operate at 10Mbps, 100Mbps, or 1000Mbps as
er different requirements. However in half duplex mode, the port cannot operate at
1.3.3 Set
able type.
Perform the following configuration in Ethernet port view.
auto-negotiated speed as per different
rnet port sup nfigured to o
100Mbps) or auto (auto-negotiat
he optical Gigabit Ethernet port su 00Mbps speed and the speed ca
et to 1000 (1000Mbps) or auto (auto-negotiation).
p
1000Mbps.
By default, the speed of the port is in auto mode.
Cable Type for the Ethernet Port
The Ethernet port supports the straight-through and cross-over network cables. The
following command can be used for configuring the c