Huawei Quidway S3000-EI Series User Manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 4
User Interface Configuration
Huawei Technologies Proprietary
4-3
Caution:
z If Telnet protocol is specified, to ensure a successful login via the Telnet, you must
configure the password by default.
If SSH protocol is specified, to ensure a successful login, you must configure the
tion of username and password using the
authentication-mode scheme command. The protocol inbound ssh
e none. When you configure SSH protocol successfully for the
z
local or remote authentica
configuration fails if you configure authentication-mode password and
authentication-mod
user interface, then you cannot configure authentication-mode password and
authentication-mode none any more.
4.2.3 Con
s can be used for configuring the attributes of the AUX
(Con speed, flow control, parity, stop bit and data bit.
I. ission speed on AUX (Console) port
figuring the Attributes of AUX (Console) Port
The following command
sole) port, including
Perform the following configurations in user interface (AUX user interface only) view.
Configuring the transm
Table 4-3 Configuring the transmission speed on AUX (Console) port
Operation Command
Configure the transmission speed on AUX (Console) port
speed speed-value
Restore the default transmission speed on AUX (Console)
undo speed
port
By default, the transmission speed on AUX (Console) port is 9600bps.
II the flow control on AUX (Console) port . Configuring
Table 4-4 Configuring the flow control on AUX (Console) port
Operation Command
Configure the flow control on AUX
(C nsole) port
flow-control { hardware | none |
software }
o
Re ntrol mode on
AUX (Console) port
undo flow-control
store the default flow co
efault, the flow control on the AUX (C
By d onsole) port is none, that is, no flow control
will be performed.

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English