Huawei Quidway S3000-EI Series User Manual

Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches
Chapter 2 AAA and RADIUS Protocol
Configuration
Huawei Technologies Proprietary
2-17
T etting the maxim retransmitting times of stopping accounting request able 2-21 S um
Operation Command
Set the
stopping a
maximum retran g times of
ccounting request
retry stop-accounting
retry-times
smittin
Restore the maximum retransmitting times of
undo retry stop-accounting
stopping accounting request to the default
value
By defa
ult, the stopping accounting request can be retransmitted for up to 500 times.
2.3.11 Se
Table 2-22 Setting the supported type of RADIUS server
tting the Supported Type of RADIUS Server
Quidway Series Switches support the standard RADIUS protocol and the extended
RADIUS service platforms, such as IP Hotel, 201+ and Portal, independently
developed by Huawei.
You can use the following command to set the supported types of RADIUS servers.
Perform the following configurations in RADIUS scheme view.
Operation Command
Setting the Supported Type of server-type { huawei | iphotel | portal |
RADIUS Server standard }
Restore the Supported Type of
RADIUS Server to the default setting
undo server-type
By default, the newly creat US scheme supports the server of standard type,
w f
huawei type.
2.3.12 Setting RADIUS Server State
For the primary and second servers (no matter it is an authentication/authorization
ne. When the second one fails to
set the primary server to be active manually, in order that NAS can
communicate with it right after the troubleshooting.
When the primary and second servers are both active or block, NAS will send the
packets to the primary server only.
ed RADI
hile the "system" RADIUS scheme created by the system supports the server o
server or accounting server), if the primary is disconnected to NAS for some fault, NAS
will automatically turn to exchange packets with the second server. However, after the
primary one recovers, NAS will not resume the communication with it at once, instead,
it continues communicating with the second o
communicate, NAS will turn to the primary one again. The following commands can be
used to

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English