Huawei Quidway S3000-EI Series User Manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 2
Logging in Switch
Huawei Technologies Proprietary
2-5
Telnet Client
PC
Telnet Server
Figure 2-7 Providing Telnet Clie
nt service
tep 1: Authenticate the Telnet user via the Console port on the Telnet Server (switch)
.

S
before login
Note:
By default, the password is required for authenticating the Telnet user to log in the
itch. If a user logs in via the Telnet without passwo
sw rd, he will see the prompt “Login
password has not been set !”.
the hostname or IP address of the Telnet
Server. If it is the hostname, you need to use the ip host command to specify.)
you will see the prompt such <Quidway>. If
se try later!” appears, it indicates that too
ugh the Telnet at this moment. In this case,
please connect later.
ds to configure the switch or view it running
state. Enter “?” to get the immediate help. For details of specific commands, refer to the
2.3 Setting up Configuration Environment through a Dial-up
the Modem
<Quidway> system-view
[Quidway] user-interface vty 0
[Quidway-ui-vty0] set authentication password simple xxxx (xxxx is the preset
login password of Telnet user)
Step 2: The user logs in the Telnet Client (switch). For the login process, refer to the
section describing “Connecting a PC to the Switch through Telnet”.
Step 3: Perform the following operations on the Telnet Client:
<Quidway> telnet xxxx (xxxx can be
Step 4: Enter the preset login password and
the prompt “All user interfaces are used, plea
many users are connected to the switch thro
Step 5: Use the corresponding comman
following chapters.
Step 1: Authenticate the Modem user via the Console port of the switch before he logs
in the switch through a dial-up Modem.

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English