Huawei Quidway S3000-EI Series User Manual

Operation Manual - VLAN
Quidway S3000-EI Series Ethernet Switches Chapter 2
Isolate-User-Vlan Configuration
Huawei Technologies Proprietary
2-2
Add new ports to isolate-user-vlan
port interface-list
An al isolate-us f which can include
m cannot be r with the Trunk port.
2.2.2 Con
ands to create a Secondary VLAN and add new ports
to it.
Configure Secondary VLAN
Ethernet switch can have sever
ore than one port. isolate-user-vlan
er-vlans, each o
configured togethe
That is to say, you cannot configure a Trunk port on the Ethernet switch already
configured with the isolate-user-vlan, and vise versa. In addition, the Uplink port has to
be added into the isolate-user-vlan.
figure Secondary VLAN
You can use the following comm
Create a secondary VLAN in system view and add new ports to it in VLAN view.
Table 2-2
Operation Command
Create a Secondary VLAN
vlan vlan-id
Add new ports ndary VLAN
port interface-list
to the Seco
Y n econdary VLAN.
2.2.3 Configure to Map isolate-user-vlan to Secondary VLAN
e
ou can add more than one port (other tha Uplink ports) to a S
You can use the following command to configure the isolate-user-vlan to map th
Secondary VLAN.
Perform the following configurations in system view.
Table 2-3 Configure to map isolate-user-vlan to secondary VLAN
Operation Command
Configure to map
isolate-user-vlan
isolate-user-vlan to secondary
isolate-user-vlan_num
secondary secondary_vlan_numlist [ to
VLAN secondary_vlan_numlist ]
Cancel map
isolate-us condary
undo isolate-use te-user-vlan_num
[ secondary se umlist [ to
mlist ]
to
er-vlan to se
VLAN
r-vlan isola
condary_vlan_n
secondary_vlan_nu
N
V
Secondary VLANs.
ote that, before you execute thi
LAN shall have ports. You ca
s command, the isolate-user-vlan and Secondary
n map an isolate-user-vlan to no more than 30

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English