EasyManuals Logo

Huawei Quidway S3000-EI Series User Manual

Huawei Quidway S3000-EI Series
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 1
Stack Function Configuration
Huawei Technologies Proprietary
1-1
A stack is created as follows. First, the user sets the optional IP address pool for the
on of stack port automatically establishes the stack relationship. If a slave
1.2 Configure Stack Function
s:
k
the configuration
1.2.1 Con u
ional IP address range for a stack first.
Chapter 1 Stack Function Configuration
1.1 Stack Function Overview
A stack is a management domain including several Ethernet switches (one main switch
and some slave switches) connected through stack ports. These Ethernet switches
stacked together can act as one set of equipment and the user can manage them
through the main switch.
When several Ethernet switches are connected through stack ports, the user can
perform configurations on one switch and set the switch as the main switch in the stack.
stack, and enables the stack function. Then the system will automatically add the
switches, which are connected to the stack ports of the main switch, to the stack. The
main switch will distribute usable IP address to the slave switch automatically as the
switch joins the stack. If a new switch is connected to the main switch via stack port,
the system will automatically add the new switch to the stack after the stack is
established.
The connecti
stack port is disconnected, that slave switch will exit the stack automatically.
The stack function configuration include
z Configure IP address pool for the stac
z Enable/Disable a stack
rform
z Switch to a slave switch view to pe
fig re IP Address Pool for the Stack
Before enabling a stack, the user shall set an opt
Then the main switch will automatically assign the slave switches with an IP address in
the range, when the slave switches are added to the stack.
Perform the following configuration in system view.

Table of Contents

Other manuals for Huawei Quidway S3000-EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S3000-EI Series and is the answer not in the manual?

Huawei Quidway S3000-EI Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S3000-EI Series
CategorySwitch
LanguageEnglish

Related product manuals