EasyManuals Logo

Huawei Quidway S3000-EI Series User Manual

Huawei Quidway S3000-EI Series
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #319 background imageLoading...
Page #319 background image
Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-25
 Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 4-45 Configuring the output format of time-stamp
Operation Command
Configure the output format of the
time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log |
trap | debugging }
4) Configuring of SNMP and network management workstation on the switch
You have to configure SNMP on the switch and the remote workstation to ensure that
the information is correctly sent to SNMP NM. Then you can get correct information
from network management workstation. SNMP configuration on switch refers to
Chapter 5 SNMP Configuration.
4.5.9 Turn on/off the Information Synchronization Switch in Fabric
After the forming of a Fabric by switches which support the XRN, the log, debugging
and trap information among the switches is synchronous. The synchronization process
is as follows: each switch sends its own information to other switches in the Fabric and
meantime receives the information from others, and then the switch updates the local
information to ensure the information coincidence within the Fabric.
The switch provides command line to turn on/off the synchronization switch in every
switch. If the synchronization switch of a switch is turned off, it does not send
information to other switches but still receives information from others.
1) Enable info-center
Perform the following operation in system view.

Table of Contents

Other manuals for Huawei Quidway S3000-EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S3000-EI Series and is the answer not in the manual?

Huawei Quidway S3000-EI Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S3000-EI Series
CategorySwitch
LanguageEnglish

Related product manuals