Huawei Quidway S3000-EI Series User Manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 2
HGMP V2 Configuration
Huawei Technologies Proprietary
2-16
Table 2-20 Set cluster timer to specify the handshaking message interval.
Operation Command
Set cluster timer to specify the
timer in
handshaking message interval.
terval
Restore the default handshaking
message interval.
undo timer
N be e ministrator device, which
the cluster timer value to the member devices.
By default, handshaking message is transmitted every 10 seconds.
2.4.10 Co
device and member devices may be
interrupted due to some configuration errors. If the member device cannot be controlled
vice to
control member device remotely. For example, you can delete the booting configuration
igured to VLAN2, the member device and the administrator device will not
ice
will automatically add the port receiving such packets to VLAN1, if the port does not
ote that the above command can only xecuted on the ad
will advertise
nfigure Remote Control over the Member device
The communication between the administrator
in regular way, you can use remote control function provided by administrator de
file and reset the member device.
Normally, the cluster packets can only be forwarded over VLAN1. In case of
configuration error, for example, the member port connected to the administrator
device is conf
be able to communicate with each other. However, you can configure VLAN check on
the administrator device to solve this problem. After this task is conducted, the
configuration information will be contained in the cluster packets. The member dev
belong to it. Thus the normal communication between an administrator device and
member device is ensured.
You can use the following command to perform the configuration.
Perform the following configuration in cluster view.
Table 2-21 Configure remote control over the member device
Operation Command
Reset member device
member { member-num |
mac-address H-H-H } [ eraseflash ]
reboot
Configure to perform VLAN check for
communicatio ster.
port-tagged v
n inside the clu
lan vlanid
Configure not to perform VLAN check for
communication inside the cluster
.
ged
undo port-tag
Note that the above command can only be executed on the administrator device.

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English