Huawei Quidway S3000-EI Series User Manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 4
User Interface Configuration
Huawei Technologies Proprietary
4-9
r can access the commands at Level 3 after logging in through the
AUX user interface, and the commands at Level 0 after logging in through the VTY user
 Note:
By default, a use
interface.
When users log into the switch, the commands they can use depend jointly on the user
level settings and the command level settings on the user interface. If the two types of
entication, the commands they can use are
use is set to level 3 and the
command level on the VTY 0 user interface is level 1, he or she can only use the
to the switch from the VTY 0 user
interface.
settings differ,
z For the users using AAA/RADIUS auth
determined by the user level settings. For example, if a
commands of level 3 or lower when logging in
IV.
he following command is used for setting the priority of a specified command in a
rements.
Set command priority
T
certain view. The command levels include visit, monitoring, system, and management,
which are identified with 0 through 3 respectively. An administrator assigns authorities
as per user requi
Perform the following configuration in system view.
Table 4-17 Setting the command priority
Operation Command
Set the command priority in a specified
command-privilege level level view
d
view.
view comman
Restore the default command level in a
Undo command-privilege view view
specified view.
command

Note:
Please do not change the command level at will for it may cause inconvenience of
m
aintenance and operation.
4.2.6 Con
I. send command
The following command can be used for sending messages between user interfaces.
figure Redirection

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English