Huawei Quidway S3000-EI Series User Manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 2
Logging in Switch
Huawei Technologies Proprietary
2-3
Environment through Telnet
VLAN interface for a switch via
nd in VLAN interface view), and added the port
command in VLAN view), you can
ole port before the user logs in by
2.2 Setting up Configuration
2.2.1 Connecting a PC to the Switch through Telnet
After you have correctly configured IP address of a
Console port (using ip address comma
(that connects to a terminal) to this VLAN (using port
telnet this switch and configure it.
Step 1: Authenticate the Telnet user via the Cons
Telnet.
 Note:
By default, the password is required for authentic
switch. If a user logs in via the Telnet without pa
password has not been set !”.
ating the Telnet user to log in the
ssword, he will see the prompt “Login
<Quidway> system-view
[Quidway] user-interface vty 0
Step 2: To set up the configuration environment, connect the Ethernet port of the PC to
[Quidway-ui-vty0] set authentication password simple xxxx (xxxx is the preset
login password of Telnet user)
that of the switch via the LAN.
Workstation
Ethernet port
Workstation
Serv er
PC ( for configuring the switch
via Telnet )
Ethernet
Workstation
Ethernet port
Workstation
Serv er
PC ( for configuring the switch
via Telnet )
Ethernet
tep 3: Run Telnet on the PC and input the IP address of the VLAN connected to the PC
Figure 2-5 Setting up configuration environment through telnet
S
port.

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English