EasyManuals Logo

Huawei Quidway S3000-EI Series User Manual

Huawei Quidway S3000-EI Series
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #192 background imageLoading...
Page #192 background image
Operation Manual - STP
Quidway S3000-EI Series Ethernet Switches Chapter 1
MSTP Region-configuration
Huawei Technologies Proprietary
1-19
lative value without units. If it is set too large, too many
packets will be transmitted during every Hello Time and too many network resourced
rt of the switch is 3.
1.2.9 Configure a Port as an Edge Port
A
c
Y onfigure a port as an edge port or t in the following ways.
I. onfigure in system view
system view.
port
This parameter only takes a re
will be occupied. The default value is recommended.
By default, the max transmission speed on every Ethernet po
n edge port refers to the port not directly connected to any switch or indirectly
onnected to a switch over the connected n
ou can c
etwork.
non-edge por
C
Perform the following configuration in
Table 1-12 Configure a port as an edge port or a non-edge
Operation
Command
Configure a port as an edge port.
terface-list edged-port
enable
stp interface in
Configure a port as a non-edge port.
stp in
disabl
te t
e
rface interface-list edged-por
Restore the default setting, non-edge
undo
port, of the port.
ce-list
edged-port
stp interface interfa
. Configure in Ethernet port view II
Perform the following configuration in Ethernet port view.
Table 1-13 Configure a port as an edge port or a non-edge port
Operation Command
Configure a port as an edge port.
stp edged-port enable
Configure a port as a non-edge port.
stp edged-port disable
Restore the default setting, non-edge port, of the port.
undo stp edged-port
You can configure a port as an edge port or a n
on-edge port with either of the
and
Manual.
port, the port can fast transit from blocking state to
BPDU protection has not been
rn into non-edge port again when
it receives BPDU from other port. In the case that BPDU protection is enabled, the port
above-mentioned measures. For more about the commands, refer to the Comm
After configured as an edge
forwarding state without any delay. In the case that
enabled on the switch, the configured edge port will tu

Table of Contents

Other manuals for Huawei Quidway S3000-EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S3000-EI Series and is the answer not in the manual?

Huawei Quidway S3000-EI Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S3000-EI Series
CategorySwitch
LanguageEnglish

Related product manuals