Operation Manual - Network Protocol
Quidway S3000-EI Series Ethernet Switches Chapter 1
ARP Configuration
Huawei Technologies Proprietary
1-4
z
z
1.3.2 Configu
The configuration tasks of the gratuitous ARP are described in the following table:
Table 1-4
network, so all hosts on the network must do this every time the ARP request is
sent.
Characteristics of gratuitous ARP packets:
The source and destination IP addresses are all native addresses, and the source
MAC address of the packet is native MAC address.
If another device receives a gratuitous ARP packet and finds out that the IP
address in the ARP packet conflicts with that of its own, it sends an ARP reply
back to the device sending the ARP packet.
ration Tasks
Configure gratuitous ARP
Sequence
number
Configuration
item
Command Description
1
Enter system
view
<Quidway> system-view —
2
earning
gratuitous-arp-learning enable
Required
Enable ARP [Quidway]
packet l
1.3.3 Con
I. Ne quirem
Enable gratuit y A.
II. Configuratio
< idwayA> s
QuidwayA] gratuitous-arp-learning enable
1.4 Disp
tion, execute display command in any view to display the
running of the ARP configuration, and to verify the effect of the configuration. Execute
ARP configuration. Execute reset
command in user view to clear ARP mapping table.
Use the corresponding undo command to cancel the configuration.
figuration Example
twork re ents
ous ARP packet learning on the switch Quidwa
n procedure
ystem-view Qu
[
lay and debug ARP
After the above configura
debugging command in user view to debug