Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches Chapter 1
802.1x Configuration
Huawei Technologies Proprietary
1-13
ximum times of the authentication request message Table 1-15 Setting the ma
retransmission
Operation Command
Set the maximum times of the authentication
dot1x retry max-retry-value
request message retransmission
Restore the default maximum retransmission
times
undo dot1x retry
By default, the max-retry-value is 3. That is, the switch can retransmit the
authentication request message to a supplicant for 3 times at most.
1.2.13 Configuring Timers
the 802.1x timers.
Configuring timers
The following commands are used for configuring
Perform the following configurations in system view.
Table 1-16
Operation Command
Configure timers
reauth-period-value | server-timeout
supp-timeout supp-timeout-val
dot1x timer { handshake-period handshake-period-value |
quiet-period quiet-period-value | rea
uth-period
server-timeout-value |
ue | tx-period
tx-period-value | ver-period ver-period-value }
Restore d
undo dot1x timer { handshake-period | quiet-period
efault
settings of the timers
|
reauth-period | server-timeout | supp-timeout | tx-period
riod }
| ver-pe
handsh ins after the user has passed the authentication.
A by the period.
S the dot1x retry time is configured as N, the system will consider the user
aving logged off and set the user as logoff state if system doesn’t receive the response
to 1024 in units
of second and defaults to 15.
the quiet timer. If an 802.1x user has not passed the
authentication, the Authenticator will keep quiet for a while (which is specified by
the quiet period,
1x authentication.
quiet-period-value: Specify how long the quiet period is. The value ranges from 10 to
120 in units of second and defaults to 60.
ake-period: This timer beg
fter setting handshake-period, system will send th
uppose
e handshake packet
h
from user for consecutive N times.
handshake-period-value: Handshake period. The value ranges from 1
quiet-period: Specify
quiet-period timer) before launching the authentication again. During
the Authenticator does not do anything related to 802.