Huawei Quidway S3000-EI Series User Manual

Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches Chapter 1
802.1x Configuration
Huawei Technologies Proprietary
1-12
III. Co
Tabl
nfiguration Procedure
e 1-14 Configure 802.1x dynamic user binding
Operation Command Remarks
Enter system view
system-view
—
Enable 802.1x dynamic
e
dot1x
Required. 802.1x
us r binding
dynamic-binding-user
enable
dynamic user binding is
disabled by default.
Display related
display dot1x [ sessio
| ] [
information
statistics interface
interface-list ]
can be executed in any
view.
ns The display command
2.1x Dynamic User Binding Configuration Example IV. 80
1) Network requirements
ddresses dynamically.
from changing their IP addresses
2)
# En
# Enable 802.1x dynamic user binding.
[Quidway] dot1x dynamic-binding-user enable
# Enable DHCP Snooping glo . (Required for 802.1x u
a
[Quidway] dhcp-snooping
#
S sted port. (Re
dynamically)
1.2.12 Se es of Authentication Request Message
Retransmissi
The tting the maximum retransmission times of the
that the switch sends to the supplicant.
igurations in system view.
z The 802.1x users obtain IP a
z Configure the switch to prevent 802.1x users
after they pass the authentication.
Configuration procedure
able 802.1x globally.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] dot1x
bally sers who obtain IP
ddresses dynamically)
Configure Ethernet 0/1 po
nooping tru
rt, which connects the DH
quired for 802.1x users
CP server, to be a DHCP
who obtain IP addresses
[Quidway] interface ethernet0/1
[Quidway-Ethernet0/1] dhcp-snooping trust
tting the Maximum Tim
on
following commands are used for se
authentication request message
Perform the following conf

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English