Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 3
Logon User ACL Control Configuration
Huawei Technologies Proprietary
3-3
II. Networking diagram
Internet
Switch
Figure 3-1 Control TELNET users with ACL
I. Configuration procedure
# Define the basic ACLs.
[Quidway] acl number 2020 match-order config
[Quidway-acl-basic-2020] rule 1 permit source 10.110.100.52 0
[Quidway-acl-basic-2020] rule 2 permit sourc
II
e 10.110.100.46 0
l 2020 inbound
h SNMP. Controlling such users with ACL can help filter the illegal NM users
and prevent them from accessing the local switch.
tion. Use the same configuration commands introduced in the last
[Quidway-acl-basic-2020] quit
# Call an ACL.
[Quidway] user-interface vty 0 4
[Quidway-user-interface-vty0-4] ac
3.3 Configuring ACL Control over the SNMP Users
Huawei Quidway Ethernet switch series support the remote management with the
network management software. The network management users can access the
switch wit
Take the following steps to control the SNMP users with ACL.
1) Defining ACL
2) Calling ACL to control SNMP users
The follow section introduces the configuration procedures.
3.3.1 Defining ACL
You can only call the numbered basic ACL, ranging from 2000 to 2999, to implement
ACL control func
section.
To Next Page
Loading...
Need help?
General