Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 4
User Interface Configuration
Huawei Technologies Proprietary
4-10
Perform the following configuration in user view.
Table 4-18 Configuring to send messages between different user interfaces.
Operation Command
Configuring to send messages between different
user interfaces.
send { all | number | type
number }
II
r a
l be automatically executed when
ed to automatically execute telnet command on the
d device automatically.
ce view.
mmand
. auto-execute command
The following command is used to automatically run a command after you log in. Afte
command is configured to be run automatically, it wil
you log in again.
This command is usually us
terminal, which will connect the user to a designate
Perform the following configuration in user interfa
Table 4-19 Configuring to automatically run the co
Operation Command
Configure to automatically run the command
auto-execute command text
Configure not to automatically run the command
undo auto-execute command
Note the following points:
z After executing this command, the user interface can no longer be used to carry
out the routine configurations
for the local system. Use this command with
caution.
Make sure that you will be able to log in the system in some other way and cancel
the configuration, before you use the auto-execute command command and
idway-ui-vty0] auto-execute command telnet 10.110.100.1
10.110.100.1 automatically.
4.3 Disp
After the above configuration, exec
r u .
Execute free command in user view
z
save the configuration.
# Telnet 10.110.100.1 after the user logs in through VTY0 automatically.
[Qu
When a user logs on via VTY 0, the system will run telnet
laying and Debugging User Interface
ute display command in any view to display the
ration, and to verify the effect of the configuration
to clear a specified user interface.
unning of the user interface config
To Next Page
Loading...
Need help?
General